Vertex VX-2000 Cables to make a repeater from YOUR two radios, MUST READ AD!!!

Description: This listing is for TWO 12 inch cables with male DB-9 connectors to plug on back on YOUR Vertex VX-2000 radios. These cables will be shipped just as shown and you can assemble the hoods (included). NOTICE: the Vertex VX2000 radios ONLY have CARRIER squelch COR control!! This means that ANY RF signal coming in the receiver will cause a "high" (+5vdc) to appear on pin 1 (COR) Wired as see below chart for detail on pin and function: TX cable Pin 3 - TX audio input WHITE Pin - 5 Ground BLACK Pin - 7 PTT input GREEN RX Cable Pin - 1 COR out BLUE Pin - 2 RX audio out YELLOW Pin - 5 Ground BLACKThe VX2000 radios are UHF (or VHF) 25-watt mobile radios capable of four or 40 channels. They are no longer manufactured. They look remarkably similar to some of the Motorola CDM and GTX radios.Interfacing is accomplished through an accessory jack on the back of the radio. This connector is a DE-9 female receptacle. The following table describes the various pins, their function, and ways of configuring them internally.J1003 DE-9 Connector Assignment Pin OutPinSignalDefault and Alternate Configurations, Signal Levels, Notes1Squelch OutputHigh level (5VDC / 47k ohms) when ANY carrier received. There is no regard for any kind of coded squelch, just RF signal.2Receive Audio OutputDFLT - De-emphasized Audio Output: 100mV, 10k ohm. The output level is fixed at the factory by having no jumper at JP1003 and soldering the jumper at JP1002 on the Main unit. ALT - Flat (not De-Emphasized) Unmuted Audio Output: 250mV, 10k ohm. Unsolder the jumper at JP1002 and solder a jumper at JP1003 on the Main unit.3Transmit Audio InputDFLT - Pre-Emphasized / IDC / Splatter Filtered Audio Input: 2.5mV, 600 ohm. This input is fixed at the factory by attaching capacitor C1254 across JP1005 and soldering a jumper at JP1004 on the Main unit. ALT - Flat (not Pre-Emphasized) Audio Input: 650mV, 10k ohm. Remove the jumper at JP1004 and solder a jumper across JP1005 on the Main unit.4Not Used 5GroundSignal ground.6Auxiliary OutputDFLT - Not Used. No jumper across JP1001 on the Main unit. ALT - Accessory Output: Open Connector Output. 'A' lamp On: Low, 'A' lamp Off: Open. Maximum voltage: 13.8V. Maximum sink current: 5mA. Solder a jumper at JP1001 on the MAIN Unit.7PTT InputGround for TX, float for RX.8+5VDCSwitched and regulated 5VDC at 50mA.9Not Used

Price: 39.95 USD

Location: Fort Collins, Colorado

End Time: 2023-08-12T23:51:25.000Z

Shipping Cost: 6.95 USD