Smart Jumper Cable Connector Alligator Clamp Booster Battery Car Jump Starter

Description: Specification Model: A1 Color: Black / Red Wire Gauge: 10 AWG Assembly Required: No Applicable: EC5 Socket Power Material: Copper, ABS Voltage: 12V Peak Current: 600A Total Wire Length: About 45cm/17.72in Weight: 0.19kg/ 0.42 lbs Battery Clamp Length: 9.5cm/3.74in Product Size: 10*4.5cm/ 3.94*1.77 in Package Size: 20.9*7*2cm/8.23*2.76*0.79 in Package Included 1* Battery ClampSmart Jumper Cable Connector Alligator Clamp Booster Battery Car Jump Starter Description Have you ever had the experience of being forced to be stranded on the highway when your car ran out of power? After being trapped, you call for help, but it takes too long for the rescue team to come. With this battery clamp, it can quickly help you restart your car's power and get you out of the dilemma of being stranded. Key Features Anti-short Circuit: Battery clamp positive and negative electrodes with electric misclip short circuit protection. When the positive and negative clamps are connected together, it will automatically disconnect. Anti-reverse Charging: This product can block the car battery to the emergency power reverse charging, so you do not have to worry about the car power will be charged less and less. Anti-reverse Connection: When the two are accidentally connected incorrectly, the starter power supply and the positive and negative clamps will automatically power off to ensure safety. Anti-over-discharge: When the starting power circuit is too low, this product will issue a reminder, such as starting again will damage the power supply. Anti-overcurrent: If the starting power supply current is too large when starting the car, this product will send a reminder and terminate the operation, which can protect your car and power supply well. Stable Voltage: This product has a stable 12V voltage, it can supply power smoothly to protect the car starter. High-quality Material: This product is made of high-quality copper, ABS plastic shell, and thickened silicone wire as raw materials. Therefore, it has good electrical conductivity, water resistance, and wears resistance performance. Timeout Disconnect: The product will be automatically disconnected after 3 seconds of a successful startup. It can effectively protect your battery and personal safety. Overheat Protection: When the product is started several times and the temperature is too high, it will automatically stop to protect the battery and PCB board. Details Color Distinction: The red clamp is the positive pole and the black one is the negative pole. The two clearly colores allow you to easily distinguish. Groove Pattern: The end of the battery clamp has a groove pattern, which can effectively increase friction and make the clip easier to hold and use. Pure Copper Gold Plated Interface: The pure copper gold-plated interface has the advantages of low resistance, good conductivity, low heat generation, and long life. Highly Flame Retardant PCB Board: The PCB board built into the product is not only highly flame retardant, but it is also very precise and maintainable. Once a failure occurs, it can be replaced efficiently, quickly, and easily. How to Use Add the red collet to the positive terminal of the car battery, and the black collet to the negative terminal of the car battery.EC5 plug into the emergency starter power starts port.The battery clamp work light becomes red and green alternately, indicating the correct connection.Within 30 seconds after the battery clamp is connected correctly, go to the car to start car. (Before starting, please turn off the air conditioning, audio, and high-powered electrical equipment; some cars need to open the car headlights before starting.) .Within 30 seconds after the successful start, please release the battery clamp from the car battery. Application This product is suitable for EC5 port power. It is suitable for 12V gasoline vehicles and is compatible with most car mini jump portable starters and mobile chargers and can start faster when fully charged with 4 cells. Specification Model: A1 Color: Black / Red Wire Gauge: 10 AWG Assembly Required: No Applicable: EC5 Socket Power Material: Copper, ABS Voltage: 12V Peak Current: 600A Total Wire Length: About 45cm/17.72in Weight: 0.19kg/ 0.42 lbs Battery Clamp Length: 9.5cm/3.74in Product Size: 10*4.5cm/ 3.94*1.77 in Package Size: 20.9*7*2cm/8.23*2.76*0.79 in Package Included 1* Battery Clamp NotesPlease don't start the car continuously with the ignition on or twist the key and don't release it, each start needs more than 1-minute interval.Please remove the battery clamp within 30 seconds after starting the car.The positive and negative poles cannot be reversed. Otherwise, it will easily cause a short circuit.If the number of battery indicators is less than 3, please do not use the jumper starter to start the vehicle in order to protect the jumper starter from damage.This product should not be overloaded. Please check the power supply of the equipment before use.Please check if the product supports your car.Please allow the slight color difference caused by the shooting light and the 1-3 cm error due to manual measurement, and make sure you do not mind before ordering.The interface corresponds to the CE5 connector Applicable voltage 12v The clips are three strings, and the customer's products are also three strings (the batteries should also be connected in parallel with three cells) PaymentDelivery detailsTerms of salesAbout usContact usPayment We accept ebay payment 。Fees such as import duties, taxes are not included in the item price or shipping costs. These charges are the buyer's responsibility.Delivery detailsShipping: 2-9 working days to: USA Terms of sales We maintain high standards of excellence and strive for hundred percent customer satisfaction. Feedback is very important to us. We hope that you contact us immediately before you give neutral or negative feedback, so that we can address your concerns. It is impossible to address issues if we do not know about them! About usYour satisfaction is our ultimate goal. We work hard to earn your trust and future business. Our certified technicians have tested each item before shipping. The unit comes with 1 year limited warranty on all manufacturing defects.a) If you receive a defective item, you may return it or ask for a discount. Please contact us within 14 days after you receive the package.b) What you returned must be intact and in its original packaging as re? u. Customer is responsible for shipping costs of the returned item.c) We will cover the cost of shipping back t with the shipping rate indicated in the registration page. We will send you a new unit or refund the full payment you paid.Thank you.Contact usBusiness Hour Business Hour: Monday To Friday: 8:30 AM to 5:00 PM (Beijing China time)Due to time zones, our reply to your questions may not be immediately. But within above working time, we will reply your email within 24 hours. If it's non-workdays, please kindly be patient and wait till Monday.Please contact us with ebay message.Please feel free to contact us if you have any questions. Monday To Friday: 8:30 AM to 5:00 PM (Beijing China time)Due to time zones, our reply to your questions may not be immediately. But within above working time, we will reply your email within 24 hours. If it's non-workdays, please kindly be patient and wait till Monday.Please contact us with ebay message.Please feel free to contact us if you have any questions.PlatformSKUQC6SYDP7WDML8BrandUnbrandedManufacturer Part NumberDoes Not ApplyTypeJump StarterFeaturesShort-circuit proofVoltageDoes not applyPeak AmpsDoes not applyCapacityDoes not applyConnectorCE5AccessoriesN/AOn Nov 3, 2024 at 22:52:03 PST, seller added the following information:

Price: 12.64 USD

Location: Chino, California

End Time: 2024-12-04T06:31:58.000Z

Shipping Cost: 0 USD