Ryobi Double Thin Bits Holder For Wall, Pegboard, Or Ryobi Wall Rails System

Description: Ryobi Double Thin Bits Holder For Wall, Pegboard, Or Ryobi Wall RailsThis is a Bit Case Holder for two thin Modular Ryobi Bit Cases but does not work with all Ryobi Bits Cases. See photos and dimensions below for the common type of cases it holds. Edges are mitered to be smooth and durable. The back is designed to mounted in a variety of ways including screws to the wall, pegboard* with holes at 1" on center, and Ryobi Link Wall Rails. If mounting to the wall with screws or Ryobi Link Wall Rails, pegs stay recessed on the back and are not used. If mounting on pegboard*, pry pegs (with a small flat screwdriver) out and push into the holes. 2 curved pegs go into the top holes pointing upward and 2 straight pegs go into the bottom holes. We recommend you superglue them into place. 2 extra pegs (one curved & one straight) are included. If mounting to the Ryobi Link Wall Rails, it can be used with or without an additional screw to hold it into place. Bits, Cases, and screws are not included. It is designed to hold two THIN Modular Ryobi Bit Cases that are 1.5" x 3.75" x 7.3"(39mm x 95mm x 185mm) with mitered corners. Most of these bit cases have a clear cover on one side (only). Note that these cases are thinner than the 2.1" (55mm) wide versions, of which we also sell compatible holders (see separate listing). Cases shown in photos are for reference only. * Note that there are many different types of pegboard and some may not work. This was designed to work on 3/16" thick masonite pegboard with holes at 1" (25.4mm) on center only. It is 3D-printed in black PLA plastic. It is 3.4" x 5" x 5.3" (87mm x 126mm x 135m

Price: 11.95 USD

Location: Lexington, Kentucky

End Time: 2024-03-09T13:07:32.000Z

Shipping Cost: 0.25 USD