Non-Contact 3 Phase Sequence Rotation Tester LED Indicator Detector Meter Tester

Description: Non-Contact 3 Phase Sequence Rotation Tester LED Indicator Detector Meter TesterDescription:This non-contact phase rotation tester designs for quick , easy and accurate detection of three phase sequence in motor installation and repair . The non-connection to insulated conductor avoids uncertain and difficult connections to bare high voltage wires. This is a phase detector, designed to perform phase sequence checks and live line checks of a 3-phase circuit using a static induction voltage clip. The static induction voltage clips are used to be able to clip on a cladded wire. It is small with a CAT 600V safety rating. Red LED lamps are used to make the indication visible in dimly lit areas. The direction of phase sequence can be checked easily using the LED lamps, which blink in order. Different from the traditional phase sequence detection,which must pull 3 phase wire and connect to exposed live wire.Our phase rotation meter adopts a clamp-type non-contact inductive measurement,without removing phase wire or touching exposed high-volt live wire.Phase sequence can be detected by simply clamping insulating sheath of 3 phase live wire with three clamps,which greatly improves safety of the test,effectively protects the personal safety of operator. Specification:1). Basic SpecificationFunction Phase detection (positive/negative) Voltage detection methodStatic induction Object to be connectedInsulated wire (nominal sectional area of the conductor: 2 to 120mm2, finished outer diameter: up to 17mm) Performance-guarantee voltage range 3-phase, 70V to 600 VAC (sine wave,continuous) Operating frequency range 45Hz to 66Hz 2). Display Phase-detection indication Positive phase sequence: The four phase-sequence lamps blink order (clockwise) and the buzzer sounds intermittently. Negative phase sequence: The four phase-sequence lamps blink in order (counterclockwise) and the buzzer sounds continuously. Line-voltage indication R-S lamp, S-T lamp Power indicationPower ON lamp: lights up (Power ON)blinks (Battery Low) 3). General SpecificationOperating temperature and humidity -10 to 40(32 to 104), 80%RH or less ( with no condensation) Storage temperature and humidity -20 to 60 (-4 to 140), 80%RH or less (with no condensation) Location for use Altitude up to 2000m(6562 feet), indoors Maximum rated voltage to earth 600V Dielectric strength 5.4kVrms Power supply Rated supply voltage 1.5VDC×2 Two AA size batteries Maximum rated power 300mVA Continuous operating time* Approx.70 hours(Power ON, Standby state, using R6P manganese battery) *Battery life Auto Power Off (This function can not Be canceled.) The power will be turned off automatically if the Instrument remains idle for 5 minutes after the power is turned on. To reset, turn the power on again using the Power ON switch. Cable length Approx. 0.7m Dimensions and mass Approx. 70W×75H×30Dmm(2.76W×2.95H×1.18D) (excluding projections), Approx. 200g(7.1oz) Applicable standards Safety EN61010-1:2001,EN61010-031:2002 Pollution degree2, Measurement category CAT III(600V)(anticipated transient overvoltage 6000V) EMC EN61326:1997+A1:1998+A2:2001 Operation:1.Phase Detection CAUTION ! HIGH VOLTAGE ! (1)Connection: Connect the three non-contact alligator clips to the three phase power cables. (2)The symbol or each clip should be placed at the center of each cables. (3)Press "ON",lightA,B,C flashes once to power on the tester. (4)In case the A,B,C are lit up , R is on if positive CW is detected. If in negative CCW, L is on. If one or more of light A,B,C does not light up , it means the relevant phase is open. In this case, R or L does not represent the indication. (5)Press "OFF" to shut down the tester after use. 2.Live Voltage Detection CAUTION ! HIGH VOLTAGE ! (1)Connect any of the alligator clips to the conductor. If the conductor is powered on (Voltage within 70~600V AC),the relevant light A,B,C should light up.This can quickly determine if the conductor is powered on. (2)Clips and lights reference table.Clips Lights A (yellow ,left) Light A B(green ,middle) Light B C(red , right) Light C Package Include: 1pc x Phase Detector 1pc x Accessory bag 1pc x English manual PaymentDelivery detailsReturn PolicyAbout usContact usPayment1. We accept PayPal only.2. Credit card (Visa, Eurocard/MasterCard, Amex, and Switch or Visa/Delta) payment can be accepted ONLY through PayPal.3. Other payment methods (Bank transfer, Cheque, etc.) are NOT acceptable.4. Please make the payment within 3 days.Delivery details1. We ship to WORLDWIDE .2. Item will be shipped out within 1-2 working days (except weekends and holidays) after the payment is cleared or received.3. We will send item to your Confirmed Shipping Address in Paypal only.Please confirm your order and address before you bid or pay the item.4.International Buyers Please Note: 1)Please check with your country customs office to determine what these additional costs will be prior to bidding / buying. 2)Import duties, taxes and charges are the buyer’s responsibility,please understand. Return PolicyItem may be returned for refund or replacement within 30 days of the purchase date. Defective products may be returned for repair up to 1 year from the purchase date. Repairs will be processed through the manufacturer, we will assist in the repair procedure in any way we can to expedite the process.Before any return, a Return Merchandise Authorization (RMA) must be obtained by contacting the seller. Any products returned to us without an RMA will be sent back to the buyer at his/her expense. The buyer is responsible for the cost of returning any merchandise.About usWe are a professional worldwide Professional company. We are reliable supplier to both wholesalers and retail sellers. We supply many products on Automobile consumer.Also offer reasonable prices , excellent customer service and a reliable credit standing are our target!Contact usOur normal business hour is Monday to Friday 9:00 AM to 6:00 PM Beijing TIME. Please email me through "MY MESSAGES" on eBay, if you have any questions about our listings or inventory or troubles. All messages be reply within 24 hours. Welcome your any-time parchase!

Price: 35.99 USD

Location: Shenzhen

End Time: 2023-08-27T11:42:09.000Z

Shipping Cost: 0 USD