kLite Adventure Lighting & Charging System Kit (MTB)

Description: Designed and built for adventure, the kLite Ultra V2 Adventure Lighting System has been tried and tested in some of the most extreme racing environments around the world. From lighting and powering athletes for countless hours on the Triple Crown-the Tour Divide, the Colorado Trail, and the AZT-- to winning the epic Silk Road Mountain Race in Kyrgyzstan, this lighting system is built to go the distance. The kLite ULTRA V2 Adventure Light is best light in the kLite range for navigating rough tracks at low speeds. With its specifically selected optical elements it provides the best overall visibility of everything that's in front of you, allowing you to ride and race further. Compatible w the kLite QUBE rear flashing light (sold separately), for extra safety and peace of mind. Throwing a bright ultra wide beam the kLite Ultra V2 Adventure Light is perfect for sketchy descents and tight cornering on singletrack, illuminating brightly even at low speeds. Below: Adventure Model Beam Pattern (Left) Vs. Race Model Beam Pattern (Right) Built tough, and with charging key electronics in mind, this is a field repairable system that can be relied upon when you're in the middle of nowhere. Perfect for rough terrain races like the Silk Road Mountain Race, the AZT, the Colorado Trail, or backcountry adventures like Australia's Hunt 1000. It shares popularity with the ULTRA Race (gravel) model for the Tour Divide and GDMBR because of the high percentage of wide open gravel roads on that route. Included in the kit: * kLite Ultra V2 Adventure light with Handlebar Mount Kit * kLite Micro USB Charger with "Y-Connector" for two simultaneous USB connections * Wire loom with SON two blade dynamo hub interface * Bar switch to toggle your front lamp on and off * Superfly kLite cycling cap * Dielectric grease to protect your USB connections from the elements * UV-resistant zip ties to complete your wiring solution Manufactured in Australia - two year warranty. ULTRA Adventure Lamp: Wide 1,300 Lumen Triple Beam: 2x Flood, 1x Spot Optics. Intended for MTB singletrack riding but also at home on a long gravel stretch, your local bikepath, or even on your potholed commute, the ULTRA MTB uses diffused lenses on the two outside lamps to provide 180 degrees of lighting, and the center lamp projects out to illuminate the trail ahead of the rider. On twisty singletrack, illuminating your immediate surroundings is critical-and this is where the "down the road" illumination provided by traditional dynamo lamps fall short. Below 13kph / 8mph (on a 29er wheel, slower on an 27.5), the ULTRA V2 boosts the power from the dynamo, providing dramatically more illumination than any other dynamo light at slower speeds. At 13kph / 8mph, the center spot kicks on to provide even more-with a boost of down the trail illumination. Many say that the combination of the wide and spot beams on this lamp allow them to leave their helmet mounted lights at home, reducing overall weight and complexity. The configuration also helps prevent light flare off near-to-the-trail obstacles--a factor which can lead to eye strain. The unit also has capacitive storage which provides wide flood light in low power mode for up to 15 minutes without incoming power - ideal for hike-a-bike, on-the-trail maintenance, and a quick camp setup. When coupled with the kLite USB charger and kLite wiring loom, this unit provides a turnkey ultra-endurance platform designed to keep your electronics charged and you on the trail. Ships with a handlebar mount kit. * 1300 lumen front light utilizing 2 x Flood and 1 x Spot optical elements * Flood optical elements provide a 180 degree beam allowing you to see everything that's in front of you. * Spot optical element kicks in as your speed increases allowing you to see further down the road. * Standby Flood mode when slow or stopped (up to 15 minutes) means you can always find your way or make camp. * The kLite low speed power booster is designed to provide more output power at low speeds than regular dynamo lights. * 135 grams kLite MICRO USB Charger (rectangular version): Designed to charge your electronics while you're "on the go"! The design of the kLite Micro is "in line"--meaning that the wire loom input is on one side and the USB-A output is on the other. It can be placed in your top tube bag or simply zip tied to your handlebars in a way that makes charging access convenient to you. The device is waterproof, meaning that it can be used inside or outside of your bikepacking bags--provided you use a bit of dielectric grease (included) on the USB-A ports to prevent surface rust. Avoid using dielectric grease on the yellow friction-fit kLite terminals. Built around universal compatibility, the MICRO works with 99.9% of dynamo hubs and with all key electronics like cache batteries, gps trackers, phones and lights, so its pretty much plug & play with any USB powered device. Tiny form factor, perfect for storing in bags or zip-tying to frames or forks. Ships with a USB-A "Y-Connector" that allows you to simultaneously power your kLite Qube rear safety light while charging your critical devices. * 2" long by 0.5" wide * Mounts on bars, stem, or frameset with two zip ties (four included) or can be placed in a bikepacking bag. * Has red indicator light that shows charging state * Rectified 5v DC USB output * 1400mA Max power output (500mA typical / average) * Ships with a small tube of dielectric grease to protect your USB connections from the elements * 20g kLite "USB ALWAYS ON" Dynamo wire loom with integrated lamp switch: The trail lamp and dual USB charger are connected by an "expedition rated" wire loom that provides a positive, waterproof connection to your dynamo hub. Toggle the switch on and you have lights and USB charging, toggle the switch off, and the lights are off and you have USB charging only. This "always on" USB functionality is perfect for endurance riders who need constant GPS charging and for those interested in the kLite QUBE--a blinking or solid rear or front/rear safety light accessory available separately. Do not use dielectric terminal grease on the yellow end connectors of the kLite system - these are waterproof by design and the use of dielectric grease here will make the kLite friction-fit connectors vibrate loose on the trail. Note that due to demand characteristics in the markets we serve, we do not ship the "Lamp or USB" loom with this kit - it is available separately. * Switch to dynamo: 31 inches * Switch to USB: 16 inches * Switch to Lamp: 8 inches-note that the ULTRA lamp has a connection that is 12 inches * Includes zip ties for mounting to stem or handlebar * 65g kLITE Aluminum Alloy Handlebar Mount Kit. This Aluminum Alloy handlebar mount allows you to put your kLite ULTRA lamp out in front of your handlebars and keeps it steady under the worst of conditions. It uses the 3 lobe / 2 lobe camera mount system and quickly and easily mounts to your kLite ULTRA lamp. Designed around 35mm handlebars and includes a shim for 31.8 bars. Includes stainless steel hex hardware on all adjustment points. Allows the elevation of the kLite ULTRA in front, above, or below the handlebar or handlebar extender to project above and beyond any handlebar bags and free up bar space. 49g without shims.

Price: 409.95 USD

Location: Carmel, IN

End Time: 2025-01-08T15:11:55.000Z

Shipping Cost: 0 USD