Description: Engine Timing To Engine Barring Tool Installation 1. Remove the two bolts holding the inspection cover to the flywheel housing. 2. Remove the pin from the engine barring tool (J–46392) . 3. Install the tool in the flywheel housing and secure with two bolts of sufficient length. Note: The inspection cover bolts are not long enough to install the engine barring tool. Longer ones will be needed. 4. As needed, insert the pin to lock the tool and block movement of the flywheel ring gear. DD13 DD15 DD16Camshaft Timing Verification - Check as follows: 1. Remove the valve cover. 2. Bar the engine to TDC #1 with the #6 valve in overlap. 3. Locate the mark on the camshaft and mark the top of the corresponding tool with a light colored paint pen. 4. Remove the Crankshaft Position Sensor from the flywheel housing. 5. Install the TDC locating pin (W470589001500) through the Crankshaft Position Sensor hole in the flywheel housing and engage into the flywheel notch. 6. Install the rear timing plate (1) (W470589054000) onto the cam housing. 7. Install the front timing tool (2) (W470589054000) into the grooves cut into the cams and pin it into the cam housing. Once it is in place, install a bolt into the tool to hold it in place. 8. Verify that the marks on the gear match the marks on the timing plates.
Price: 109.9 USD
Location: Edison, New Jersey
End Time: 2024-12-22T07:46:59.000Z
Shipping Cost: 0 USD
Product Images
Item Specifics
Restocking Fee: No
Return shipping will be paid by: Buyer
Returns Accepted: Returns Accepted
Item must be returned within: 30 Days
Refund will be given as: Money Back
Brand: DPTOOL
Manufacturer Part Number: Does Not Apply
UPC: Does not apply
