Bob Smith CA Glue Cyanoacrylate Insta-Cure+™ Super Glue Various Sizes

Description: Brand new. Message us with any questions. To purchase multiple glues and save on shipping, add the glues to your cart and combined shipping will be calculated at check out. If you are looking for something that you don't see here, send us a message and we'll see if we have it. Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ ™ should also be used. To prevent premature curing, don’t spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out. Works Best On:Balsa WoodSoft WoodWorks Good On:Hard WoodGlass & MetalFiberglassCeramicsHard PlasticsRubberLaminatingWater-ResistantReinforcingDirections Unscrew top from nozzle. For finer applications, use the extender tip. Apply Insta-Cure+™ CA to one side of the parts being joined, then hold them tightly together for 5-15 seconds. For larger bonding areas, apply serpentine beads of the CA with enough spacing to allow for the spreading of the adhesive. Insta-Set™ accelerator can be sprayed to cure the CA that oozes from joints. Full strength is reached in three hours. Wipe the nozzle clean before replacing screw-on top. Refrigerate to extend shelf life. Cured CA is stable from -40 to 220° F. Soak extender tip in acetone for cleaning.

Price: 4.79 USD

Location: Annapolis, Maryland

End Time: 2023-10-14T18:33:41.000Z

Shipping Cost: 4.5 USD