2nd Quality - Browning A5 Buttstock Unfinished from Belgium factory

Description: This is the 2nd quality (off-quality) version of my browning A5 stock listing. The description is the same as the 1st quality listing except these stocks have very minor defects. The minor defects will need a dab of wood filler to correct. The most common defect is a small Knick where the stock mounts to the tang, as it was simply dinged while in storage. Price has been reduced to reflect this. ——————————————— All holes are drilled and ready. No machining required. These are designed to be used with the thick rubber recoil pads, NOT the hard plastic thin buttplates. The difference is that these stocks are an inch shorter than stocks made for the thin buttplates to make up for the recoil pad thickness. Pairs well with Browning A5 recoil pads as the screw hole distance on the end of the buttstock is 3.125 inches. TO REITERATE, PAIRS WITH RECOIL PADS, NOT BUTTPLATES. The top tang inlet is 3.625 inches long. The bottom cut is 3.25 inches long. The front to front of the grip is 4.75 inches. The entire stock is about 12-12.5 inches long. The height at the front end is about 1.75 inches. Width at the front end is about 1.4375 inches. Fits on my 12GA Browning A5 from 1957. The stocks are european walnut. Some have dark grain, some have light grain, and some are a mix of both. Some have tiger striping. All look nice when sanded and oiled. The first 10 pictures in this listing shows an unfinished “before" stock. The last two show a sanded and polyurethaned “after" stock. The unfinished “before” stock is what you'll receive. The “after” stock is after I sanded and oiled one of the stocks. It is an example of what the stock may look like after some light finishing. All thats left is sanding to get the stock to fit snug to your shotgun and to get the outside looking nice. My recommendation is 80 grit to 150 to 220 and then possibly 320. Apply several coats of tung oil or boiled linseed oil. Then apply Polyurethane or nitrocellulose or finish of your choice if you would like a protective coat over the oil. Browning A5 Buttstock Unfinished from Belgium factory. Each one is dry and will need to be sanded and oiled. The tang screwhole is drilled as shown. The inlet is cut/drilled as shown. This stock wont need extra work aside from small sanding to get it to fit snug to your rifle and look nice. Some have pencil marks, dates ranging from 1974-1976, and "NF" written on them from the FN factory in Belgium. All writing is intended to be sanded off. Condition is "New". Shipped with USPS Priority Mail.

Price: 40 USD

Location: Huntersville, North Carolina

End Time: 2024-11-21T13:10:55.000Z

Shipping Cost: N/A USD